欢迎访问《中国临床药理学与治疗学》杂志官方网站,今天是

中国临床药理学与治疗学 ›› 2022, Vol. 27 ›› Issue (1): 70-76.doi: 10.12092/j.issn.1009-2501.2022.01.010

• 临床药理学 • 上一篇    下一篇

丁苯酞注射液在中国健康人体内的生物等效性研究

蔡名敏1,2,邵 静3,唐 璐2,孙秋月2,窦 婷2,钱 薇2,王慧萍1,2   

  1. 1东南大学附属中大医院临床试验机构办公室,2东南大学附属中大医院I期临床试验病房,南京 210009,江苏;3南京优科制药有限公司,南京 210046,江苏

  • 收稿日期:2021-11-17 修回日期:2021-12-25 出版日期:2022-01-26 发布日期:2022-02-09
  • 通讯作者: 钱薇,通信作者,女,副主任药师,研究方向:临床药理学。 Tel: 025-83272210 E-mail: zdyyyqlcsybf@163.com 王慧萍,共同通信作者,女,副主任医师,研究方向:药物临床试验管理。 Tel: 025-83272084 E-mail: zdyyjgb@163.com
  • 作者简介:蔡名敏,女,硕士,药师,研究方向:临床药理学。 Tel: 15250962898 E-mail: mingmincai@163.com
  • 基金资助:
    江苏省药品监督管理局科研计划课题(202106)

Bioequivalence study of buthlphthalide injection in Chinese healthy volunteers

CAI Mingmin1,2, SHAO Jing3, TANG Lu2, SUN Qiuyue2, DOU Ting2, QIAN Wei2, WANG Huiping1,2   

  1. 1 Drug Clinical Trial Institution, Zhongda Hospital, Southeast University, Nanjing 210009, Jiangsu, China
  • Received:2021-11-17 Revised:2021-12-25 Online:2022-01-26 Published:2022-02-09

摘要: 目的:研究空腹条件下静脉滴注受试制剂丁苯酞注射液(规格:5 mL:25 mg,南京优科制药有限公司生产)与参比制剂丁苯酞氯化钠注射液(商品名:恩必普)在健康受试者体内的生物等效性及安全性。方法:采用随机、开放、两周期、双交叉给药试验设计,选择24名健康受试者分别交叉单次静脉注射丁苯酞注射液受试制剂和参比制剂100 mL,输液量(100±5) mL(输液泵允许有5%以内的误差),时间55 min。采用液相色谱-串联质谱(LC-MS /MS)法测定血浆中丁苯酞浓度,使用WinNonlin 6.4软件计算主要药动学参数,并进行生物等效性评价。结果:24名健康受试者输注受试制剂和参比制剂后,丁苯酞的主要药动学参数:AUC0-t:(541.0±78.6)ng·mL-1·h和(525.0±76.1)ng·mL-1·h;AUC0-∞:(571.0±82.1) ng·mL-1·h和(555.0±88.1) ng·mL-1·h;Cmax:(295.0±62.7) ng/mL和(291.0±56.5) ng/mL;Tmax分别为0.92(0.33, 0.92)h和0.92(0.33, 0.93)h。t1/2分别为(16.60±6.85) h和(15.80±5.88)h。受试制剂和参比制剂的AUC0-t,AUC0-∞,Cmax的几何均数比值(GMR)的90%置信区间均在80.0%~125.0%的范围内。结论:受试制剂丁苯酞注射液与原研丁苯酞注射液具有生物等效性。

关键词: 丁苯酞注射液, 高效液相色谱-串联质谱, 生物等效性

Abstract: AIM: To establish a method to investigate pharmacokinetics and bioequivalence of buthlphthalide injection. METHODS: An open, randomized, and two-cycle crossover study was conducted in 24 healthy volunteers. Plasma concentrations of buthlphthalide were determined by LC-MS/MS after administering a single dose of reference drug or test drug. Main pharmacokinetic parameters were calculated by Phoenix WinNonlin 6.4 software. RESULTS: For the test drug and the reference drug, the main pharmacokinetic parameters of flurbiprofen were as follows: AUC0-t was (541.0±78.6) ng·mL-1·h and (525.0±76.1) ng·mL-1·h, AUC0-∞ was (571.0±82.1) ng·mL-1·h and (555.0±88.1) ng·mL-1·h, Cmax was (295.0±62.7) ng/mL and (291.0±56.5) ng/mL, and the median of Tmax was 0.92 (0.33, 0.92) h and 0.92 (0.33, 0.93) h, respectively. Under two kinds of conditions, 90%CIs of AUC0-t, AUC0-∞ and Cmax of the test preparation were 80%-125% of the corresponding parameters of the reference preparation,and there was no statistical significance in Tmax between the two preparations (P>0.05).CONCLUSION: The test drug and the reference drug are bioequivalent.

Key words: buthlphthalide injection, HPLC-MS/MS, bioequivalence

中图分类号: